HUNG

Swung by the F3 shop and the quarter panel and roof skin are almost completely attached!!

They will finish dressing the welds and start prepping the body for primer and should have the two stage epoxy sprayed on her flanks by this time next week!

Stay tuned.....

ZEBRA 3 OUT

Inner structure REPAIRED....

The boys at F3 were busy on the Tomato this week! They sent me pics of the COMPLETED INNER STRUCTURE REPAIRS today and they look FANTASTIC! I'll swing by tomorrow after work for a first hand opportunity to drool over their craftsmanship....

They will probably already have the quarter and roof skin attached by the time I get there as well as the inner driver side rear bulkhead and be dressing the welds and prepping the body for the first coat of epoxy primer! Won't be long until the ball will be back in MY court!!

Tune in tomorrow for more......

ZEBRA 3 OUT

A little bit closer.....

Stopped by the F3 shop on Tuesday and the sheet metal is about 90% complete. A few more tweeks/repairs to be made to the inner structure and then it will be on to hanging the quarter and roof skins, then prepping for the epoxy primer. Sikkens have already delivered the primer materials, so by the end of next week (01/18/13) she should be once more have something on her naked body. Here are a few shots of the structure and the quarter panel in place to check fit......

Will take a few more shots of the final structure repairs prior to exterior panel attachment. Really getting excited about getting the ole girl back so I can get my hands dirty again while the guys at F3 massage the hood, fenders, deck lid.

Stay tuned......

ZEBRA 3 OUT