Well today I helped Jim install a new motor on one of the compressors then unwrapped the bulkhead connector. Will need to shoot one more coat on the backside to seal the previous coats along the cut line. (Note to future self: Mask part to hard edge so you can trim new rubber along that edge and not peel off the new layer of rubber with the tape!)
Brushed the locking hood release to clean it up a bit (I had the ignition switch rekeyed to match this key so one key will operate both locks)....
then traced out the firewall pads onto the new material...
and got them cut to shape.
Need to get some larger diameter gasket punches so I can make the larger circular cutouts as well as the corners on some of the larger opening. Dry fit them and they look like they are going to work nicely!!
Until next time....
ZEBRA 3 OUT
No comments:
Post a Comment