Details 49....

A bit more progress today.... located my hard heater lines and pulled the retaining clip off so I could paint them

along with the engine oil dip stick, painted the harmonic balancer...

and blasted and cleared the aluminum section of the engine fan clutch.

I installed the engine mounts onto the block and then set about dry fitting the MT valve covers still trying to figure out how to spread them to fit correctly), Holley carb and spacer, oil filter and the Crites headers.

Looking pretty good in my book!! Next weekend I'll install the harmonic balancer and fuel pump, pop off the headers, carb and valve covers and set this baby between the frame rail for good!!

Stay tuned....

ZEBRA 3 OUT